Hardware Installation Procedure; Panel/Wall Mounting; Din-Rail Mounting (Optional) - Moxa Technologies NPort 5250AI-M12 Quick Installation Manual

Hardware Installation Procedure

Panel/Wall Mounting

Mounting the NPort 5000AI-M12 on the wall requires three screws. Please
use the three screws provided in the product package.
STEP 1: Use the device to mark the positions of the three screw holes on
the wall, as shown in the mounting dimensions diagram.
STEP 2: Use one screw to go through the top-middle screw hole on the
device server and screw it into the wall.
STEP 3: Screw in the remaining two screws through the bottom-left and
bottom-right holes on the device server to the wall.
NOTE Please use the screws (M3 x 40 mm) included.

DIN-Rail Mounting (optional)

You may use the optional DIN-rail mounting kit (DK-TN-5308; must be
purchased separately) to mount the NPort 5000AI-M12 on a 35 mm DIN
rail.
STEP 1: Fix the DIN-rail attachment plate onto the rear panel of the
device server as shown in the figure below.
- 5 -