Switching To Stand-By - Barco R9001338 Owner's Manual

Power Connection
When the total run time of the lamp is 970 hours or more, the following
message will be displayed for 1 minute. This message will be
repeated every 30 minutes. Press EXIT to remove the message
before the minute is over.
When the total run time of the lamp is 1000 hours or more, the
following message, with the exact run time is displayed on the
screen.
Lamp run time is 1000 hours. Operating the lamp longer than 1000
hours may damage the projector. Please replace the lamp.
When OK (ENTER) is pressed to go on, the warning will be repeated
every 30 min.
The total lifetime of the lamp for a safe operation is 1000 hours max.
(normal power mode). Do not use it longer. Replace always with a
same type of lamp. Call a BARCO authorized service technician for
lamp replacement.
Warning : Using a lamp for more than 1000 hours is
dangerous, the lamp could explode.

Switching to stand-by.

When the projector is running and you want to go to stand-by, press
the stand-by key.
Caution : Before powering down the projector, switch the projector
to stand-by and let the projector lamp cool down until the fans stop
blowing (or for at least 15 minutes).
6-4
Switching off
To switch off:
- press first STANDBY key and let cool down until the fans
stop blowing ( or at least 15 min).
- switch off the projector with the power switch.
Lamp run time
980 h
WARNING
Lamp run time is 1000 hours
Operating the lamp longer
than 1000 hours may damage
the projector.
Please replace the lamp
<ENTER> to continue
5975288A BARCOGRAPHICS 8200LC 150597