Edit File - Barco R9001338 Owner's Manual

Edit file

The Edit file menu makes it possible to change the settings of the file
according to the actual settings of the connected source. Consult the
source specification before entering the data.
To start up the EDIT menu, push the control disk up or down to select
EDIT in the FILE menu and press ENTER .
Select the file which must be edited (mostly the active file) and press
ENTER .
The Edit file adaptation menu will be displayed.
The file name will be displayed in the upper right corner.
The following items can be adjusted :
Total quantity horizontal pixels
Active quantity horizontal pixels
Horizontal shift in pixels
Horizontal period in µs (is automatically adapted during the installa-
tion of a file with LOAD)
Total vertical lines (is automatically adapted during the installation of
a file with LOAD)
Active vertical lines
Vertical shift in lines
Interlaced : toggle on/off (is automatically set to its correct position
during the installation of a file with LOAD)
All settings can individually be changed. Push the control disk up or
down to select an item. The color of the selected item will change and
follow one of the three methods to change the value.
a. press ENTER to activate the digits and enter directly with the
numeric keys on the RCU or local keypad the new value or
b. press ENTER to activate the digits. Push the control disk to the
right or to the left to select the changing digit. Push the control disk
5975288A BARCOGRAPHICS 8200LC 150597
Random Access Adjustment Mode
FILE SERVICE
LOAD
EDIT
RENAME
COPY
DELETE
OPTIONS
EDIT FILE
Select with or
then <ENTER>
Filename Src Resolution
<EXIT> to return.
-----------------------------------------------------
ntsc .s01 1 675x240i
ntsc .c01 1 675x240i
ntsc .s03 3 675x240i
-----------------------------------------------------
Active file : ntsc.c50
Select with or
<ENTER> to accept
<EXIT> to return.
,
11-5