Table of Contents
Advertisement
Random Access Adjustment Mode
Load file
Push the control disk up or down to select LOAD and press ENTER
to display the Load menu.
The Load menu displays the corresponding files depending on the
installed filter.
This filter can be "Fit" or "All". To change the filter, push the control
disk to the right to select "filter list" (filter list will be hightlighted) and
press ENTER to toggle the annotation between brackets.
"All" : all files that can be loaded will be displayed.
"Fit" : only the best fitting files will be displayed (with a distinction of
± 2 lines and line duration distinction of ± 300 ns)
Push the control disk up or down to select the most fitting file and
press ENTER to select.
When scrolling through the files, the image will be adapted according
the settings of the selected file (on line adaptation). When the best
fitting image is displayed, press ENTER to select this file. 'A confirm
Load' file menu will display the newly created file and the file on which
the new file is based.
Press ENTER to confirm your new creations or EXIT to return to the
load file menu.
If the displayed image is not yet as it should be, select the most
corresponding file and go to the Edit menu to change the file settings.
During a load file, the actual active file is displayed next to the
indication 'Active file'.
11-4
FILE SERVICE
LOAD
EDIT
RENAME
COPY
DELETE
OPTIONS
LOAD FILE
Select with
or
FILTER LIST [All]
then <ENTER>
Filename
Src
Resolution
<EXIT> to return.
-----------------------------------------------------
ntsc
.s01
1
675x240i
ntsc
.c01
1
675x240i
ntsc
.s03
3
675x240i
-----------------------------------------------------
Active file : ntsc.c50
Select with
or
,
<ENTER> to accept
<EXIT> to return.
CONFIRM
LOAD FILE
Create file
ntsc.c02
based on file
ntsc.s01?
<ENTER> to confirm
<EXIT> to return
5975288A BARCOGRAPHICS 8200LC 150597
Advertisement
Table of Contents
