Change Password; How To Enable Or Disable The Password Function - Barco R9001338 Owner's Manual

Change Password

This item is password protected when the password strap is installed.

How to enable or disable the password function ?

The password function is enabled when the password strap on the
controller module is installed.
To gain acces to the controller module, handle as follows :
- Power down the projector and disconnect the power cord from the
wall outlet.
- Turn both lock screws of the front top cover with a screwdriver or coin
counter clockwise.
- Lift up and pivot the top cover. Attention : the cover is not secured
with an incorporated support. When opening, turn it over slowly and
lay it down on the second part of the top cover.
5975288A BARCOGRAPHICS 8200LC 150597
Loosen the locking
screws.
V
B
B
V
DI AGNOSTICS
CODE
I R-ACKNO WLEDGED
R R
RS232 OUT
I R-RECEI VED
Open the top cover
V
B
B
V
DI AGNOSTICS
CODE
R R I R-ACKNOWLEDGED
RS232 OUT
I R-RECEIVED
Service Mode
This device complies with Part 15 of the FCC rules. Operation
is subject to following two conditions :
(1) T his device may not c ause harmf u l interference
(2) Thi s device must accept any i n terference received
incl u ding interference that may cause undesired operat i on
I R-RECEIVER
100 - 230 V
9 - 4 A
0 I
60 - 50 Hz
This device complies with Part 15 of the FCC rules. Operation
is subject to following two conditions :
(1) T his device may not c ause harmf u l interference
(2) Thi s device must accept any i n terference received
incl u ding interference that may cause undesired operat i on
I R-RECEI VER
100 - 230 V
9 - 4 A
0 I
60 - 50 Hz
1 3 - 7