Lamp Run Time; Switching To Stand-By; Switching Off - Barco ATLAS 67 CS4 User Manual

5.1.5 Lamp Run Time

The operation time of the lamp is 8000 hours. The total hours of operations are counted and can be
displayed on the screen.
The total lifetime of the lamp for a safe operation at high and constant brightness is
about 8000 hours. Always replace with a same type of lamp

5.1.6 Switching to Stand-by

When the projector is running and you want to go to stand-by:
! Press the
STANDBY
Do not press any longer on the
! Switch off the voltage of the 24V interface.

5.1.7 Switching Off

To switch off:
! Switch off the voltage of the 24V interface or press
message
'Saving data, please wait'
otherwise the projector will restart.
! Let cool down the projector at least 10 min.
! Remove the paneling to gain access to the
! Switch off the projector with the
When switching to standby, it is possible to restart within the first 5sec. When not
restarted within these first 5 sec., you have to wait one minute for being able to re-
start again. During the period when restarting is disabled the LED display will show
a jumping square with a dash. When restarting is enabled again, two dashes will be
displayed to indicate that the projector can be restarted.
R5976255 A CS4 (2001-03)
TLAS
key for 2 seconds until the message
key otherwise the projector will restart.
standby
is displayed, do not press any longer on the standby key
power
switch.
power
'Saving data, please wai
key for 2 seconds. When the
STANDBY
switch.
t' is displayed.
5-9