Fuses; Switching On - Barco R9001338 Owner's Manual

Power Connection
Power (mains) cord connection
Use the supplied power cord to connect your projector to the wall
outlet. Plug the female power connector into the male connector at
the front of the projector.
The power input is auto-ranging from 100 to 240 VAC.
This projector may be connected to an IT-power system.

Fuses

Warning
For continued protection against fire hazard :
- replace with the same type of fuse.
- refer replacement to qualified service personnel
Fuse type : T12.5 AH/250V

Switching on

Use the power switch to switch on.
When '0' is visible, the projector is switched off.
When '1' is visible, the projector is switched on.
6-2
PROJECTOR MODE :
GREEN - OPERATION
COMMUNICATION PORT RED - STANDBY
RS 232 IN (800-PERIPHERALS) REMOTE
S-VIDEO VIDEO
MAC-INPUT
VGA-INPUT VIDEO-INPUT
S-VIDEO VIDEO
5975288A BARCOGRAPHICS 8200LC 150597
DECODER
100-240Vac
10-4.5A