Change Projector Address; Change Baudrate Pc - Barco R9001338 Owner's Manual

Service Mode

Change Projector Address

Every projector requires an individual address between 0 and 255.
This address can be software installed.
To change that address, push the control disk up or down to highlight
Change Proj. Address and press ENTER . The Change Projector
Address menu will be displayed and the actual address will be filled
in. The first digit is highlighted. Enter the new projector address with:
- the digit keys on the RCU or the local keypath or
- use the control disk to the right or to the left to select a digit and
change the value by pushing the control disk up or down until the new
value is reached. Continue with the other digits in the same way.

Change Baudrate PC

The communication speed between projector and computer, e.g. PC
or MAC, has 8 possible speeds. The baud rate speed can be software
set up.
Highlight Change Baud rate PC by pushing the control disk up or down
and press ENTER to display the Change Baudrate PC.
13-10
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
PANEL ADJUSTMENTS
I2C DIAGNOSIS
Select with or
then <ENTER>
<EXIT> to return.
CHANGE PROJ. ADDRESS
Enter new address
001
Select with or
Reprogram with or
or numeric keys
<ENTER> to confirm
<EXIT> to return
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
PANEL ADJUSTMENTS
I2C DIAGNOSIS
Select with or
then <ENTER>
<EXIT> to return.
5975288A BARCOGRAPHICS 8200LC 150597