Ir Receiver 800; Hardwired Rcu - Barco R9001338 Owner's Manual

Optional Equipment

IR Receiver 800

This infra red receiver unit makes it possible to control
the BARCOGRAPHICS 8200 from another room.
There is a communication line with cable between the
IR receiver and the projector or the RCVDS. The control
information from the RCU can now be sent to this IR
receiver.
The IR receiver 800 displays the selected source on a
7-segment display.
Order number : R9827515

Hardwired RCU.

The control signals from the RCU can be sent to the projector via a wired
connection. (How to use the hardwired RCU, see chapter Controlling)
Preparing your remote cable :
Use a shielded cable with a maximum length of 100 m and two mini-jack 3.5 mm
connectors (order number : R3131991).
- Peel back the vinyl covering of the cable on both sides and twist the wire core.
- Solder a jack plug as shown in drawing above to each end of the cable.
shield = ground
conductor = data information
When the cable is ready, plug one side in the remote control and the other side
in the connector on the rear of the projector labelled 'remote'.
1 4 - 2
Screen
Communication cable
IR Remote Receiver 800
BARCOGRAPHICS 8100
Control room
Projection room
shield
conductor
5975288A BARCOGRAPHICS 8200LC 150597