Table of Contents
Advertisement
Terminology
Back light key : when activated, all keys will be lighted up
1
and visible in the dark.
ADJ. : ADJUST key, to enter the adjustment mode or for
2
quick exit in the adjustment mode.
A ddress key (sunk key), to enter the address of the projec-
3
tor (between 0 and 9). Press the sunk address key with a
pencil, followed by pressing one digit button between 0 and
9.
STBY : stand by button - to start projection when the
4
power switch is switched on.
without switching off the power switch.
PAUSE : to stop projection for a short time, press 'PAUSE'.
5
The image disappears but full power is retained for imme-
diate restarting.
HELP : on line help information.
6
Digit buttons : direct input selection.
7
Picture controls : use these buttons to obtain the desired
8
picture analog level (see also 'Controlling').
PHASE : used to remove the instability of the image.
9
5975288A BARCOGRAPHICS 8200LC 150597
- to switch off the projector
Location and Function of Controls
TEXT : when adjusting one of the image, e.g. controls
10
during a meeting, the displayed bar scale can be removed
by pressing 'TEXT' key first. To re-display the bar scale on
the screen, press 'TEXT' key again. 'TEXT' key only active
in operational mode.
FREEZE : press to freeze the projected image.
11
ENTER : to start up the adjustment mode or to confirm an
12
adjustment or selection in the adjustment mode.
EXIT : to leave the adjustment mode or to scroll upwards
13
when in the adjustment mode.
Control disk (on RCU) or '+' and '-' keys (cursor keys): to
14
make menu selections when in the adjustment mode.
The control disk can move up, down, to the right or to the
left.
Comparision between control disk movement and the use
of the cursor keys on the local keypad :
RCU
control disk up
control disk down
control disk to the right =
control disk to the left
Use the '+' and '-' keys (cursor keys) : to increase or
decrease the analog level of the image controls when they
are first selected.
RC operating indication : lights up when a button on the
15
remote control is pressed. (This is a visual indicator to
check the operation of the remote control)
=
local keypad
=
'+' key up
=
'-' key down
'+' key right
=
'-' key left
5-5
Advertisement
Table of Contents
