Table of Contents
Advertisement
Controlling
How to display a projector address?
Press the ADDRESS key (recessed key on the RCU) with a pencil. The projector's
address will be displayed in a 'Text box'. This text box disappears after a few seconds.
To continue using the RCU, it is necessary to enter the same address with the digit buttons
(address between 0 and 9). For example : if the Address key displays projector address
003, then press "3" digit button on the RCU to set the RCU's address to match the
projector's address.
How to program an address into the RCU?
Press the ADDRESS key (recessed key on the RCU) with a pencil and enter the address
with the digit buttons. That address can be any digit between 0 and 9.
When programming '0', zero address, the RCU will control any projector regardless of the
projector's address. This feature allows multiple projectors with different addresses to be
controlled by a single RCU.
Picture controls with direct access.
When an image control is pressed, a text box with a bar scale, icon and function name of
the control, e.g. 'brightness...' appears on the screen (only if text is ON). See example
screen. The length of the bar scale and the value of the numeric indication indicate the
current memory setting for this source. The bar scale changes as the + or - buttons of the
control on the RCU are pressed or the + or - buttons on the local keypad.
Brightness Control
A correct 'brightness' setting is important for good image reproduction.
Use the + button for a higher brightness.
Use the - button for a lower brightness.
8-4
PROJECTOR ADDRESS
001
BRIGHTNESS
0
50
5975288A BARCOGRAPHICS 8200LC 150597
100
Advertisement
Table of Contents
