Reset Lamp Runtime - Barco R9001338 Owner's Manual

The following baud rates are available :
- 9600
- 4800
- 2400
- 1200
- 600
- 300
- 150
- 75
The actual baud rate will be highlighted. To change the baud rate,
push the control disk up or down and press ENTER to accept the new
baud rate setting.

Reset Lamp Runtime

Reset lamp run time is only allowed when a new lamp is installed.
Highlight Reset Lamp Run Time by pushing the control disk up or
down and press ENTER to select.
When Reset Lamp Run Time is selected in the Service Mode
selection menu, the following warning will be displayed :
Risk of electrical shock. Reset lamp run time is reserved to qualified
service personnel.
If you are not qualified, press EXIT to cancel the reset operation.
5975288A BARCOGRAPHICS 8200LC 150597
Service Mode
CHANGE BAUDRATE PC
9600
4800
2400
1200
600
300
150
75
Select with or
<ENTER> to accept
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTINE HISTORY
MORE
Select with or
then <ENTER>
<EXIT> to return.
WARNING
-----------------------------------------------------
RISK OF
ELECTRICAL SHOCK
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
LAMP RESET RUN TIME
is reserved to
qualified
service personnel
<ENTER> to accept
<EXIT> to return.
13-11