Video/S-Video Input Module - Barco R9001338 Owner's Manual

Video/S-video input module

To the Video input :
Composite video signals from a VCR, OFF air signal decoder, etc...
1 x BNC 1.0Vpp ± 3 dB
To the S-Video input :
Separate Y-luma/C-chroma signals for higher quality playback of
Super VHS-signals.
1 x 4 pins plug (mini DIN)
pin configuration :
1 ground luminance
2 ground chrominance
3 luminance 1.0 Vpp ± 3 dB
4 chrominance 282 mVpp ± 3 dB
Input selection :
Key in the corresponding slot number on the RCU or the local
keypad. Depending on the priority setting in the Input slots
menu, Video or S-Video will be displayed. If the wrong
source type is displayed, start up the adjustment mode and
select Installation. Select the Input Slots menu. Highlight the
corresponding slot number with the control disk and press
ENTER to change the priority setting. To start up the
Adjustment menu, press ADJUST or ENTER .
5975288A BARCOGRAPHICS 8200LC 150597
On
S-Video input
R
R
RS232 OUT
RS 232 IN
G
G
Luma/Chroma
VCR S-VHS
TV tuner, e.g.
TVDM 40 stereo
VCR
On
VIDEO/S-VIDEO INPUT
Audio input not
available
This devi c e complies with Part 15 of the FCC rul e s. Operati o n
is subj e ct to fol l owing two condi t ions :
(1) Thi s device m ay not cause harmful interference
DIAG NO STICS (2) Thi s device m ust accept any i n terference received
incl u ding interference that may cause undesired operation
CO DE
IR-RECEIVER
IR-ACKNOWLEDGED
IR-RECEIVED
Composite
Video
Audio amplifier
Connections
Video input
100 - 230 V
9 - 4 A
0 I
60 - 50 Hz
7-3