Convergence - Barco R9001338 Owner's Manual

Installation

Convergence

Highlight "Convergence" by pushing the control disk up or down and
press ENTER to display the convergence selection menu.
Every LCD panel has 6 adjustment screws. By turning these screws
you change the relative position of the panels and converge the
image.
Always start with the adjustment of the green panel. When the green
image is correctly focused, it will later on be used as the reference
image to converge the red and blue image.
Next alignments have to be done :
You have to adjust the green panel until the indicated lines on the
screen are focused (sharp lines). Continue with the red panel and
adjust until the red lines coincide with the green lines. Than continue
with the blue panel until the blue lines coincide with the green lines.
Follow the next procedure to adjust the LCD panels.
* Open the top cover as described in Change password in chapter
Service Mode .
The three mounting parts for the LCD's (two are shown on the
drawing below) are located on the black metal cover. The screws are
indicated from 1 to 6 for each color.
12-4
INSTALLATION
INPUT SLOTS
CONVERGENCE
CONFIGURATION
INTERNAL PATTERNS
Select with or
then <ENTER>
CONVERGENCE
<EXIT> to return.
GREEN
BLUE ON GREEN
RED ON GREEN
HATCH
Select with or
then <ENTER>
<EXIT> to return.
5975288A BARCOGRAPHICS 8200LC 150597