Table of Contents
Advertisement
Installation
The three alignments influence each other, therefore repeat if neces-
sary the above three steps (b,c and d).
When the green pattern is correctly focused, press EXIT to return to
the Convergence menu.
Red on green convergence.
Use the control disk to hightlight Red on green and press ENTER to
display the Red on green test pattern.
The longest lines are the red lines. These lines must be converged
with the green lines.
The drawn screws and numbers are displayed in red.
Follow next steps :
a. Adjust first screws 4, 5 and 6 to obtain an optimal focus for
respective lines 4, 5 and 6.
Due to interaction, it may be necessary to repeat step a several times.
Follow next steps to converge the red lines with the green lines :
b. Start with screw 2 and adjust for optimal convergence of line 2.
c. Adjust screw 3 for optimal convergence of line 3.
Due to interaction repeat above two steps (b and c) if line 2 and
possibly line 3 is misaligned.
12-6
CONVERGENCE
GREEN
BLUE ON GREEN
RED ON GREEN
HATCH
Select with
or
then <ENTER>
<EXIT> to return.
4
1
6
3
2
5975288A BARCOGRAPHICS 8200LC 150597
5
Advertisement
Table of Contents
