Lamp Run Time; Lamp Run Time Warning; Switching To Stand-By - Barco R9001950 Owner's Manual

Connections
To start image projection :
a. press the 'Stand by' button once on the local keypad or on the remote control. The projector mode indication lamp will be green.
b. press a digit button to select an input source. The projector mode indication lamp will be green.

Lamp Run Time

When the total run time of the lamp is 970 hours or more, the following warning message will be displayed for 1 minute. This warning
message will be repeated every 30 minutes. Press EXIT to remove the message before the minute is over.
Remaining
Lamp run time
20 h
When the total run time of the lamp is 1000 hours or more, the following warning message, with the exact run time is displayed on
the screen.
WARNING
Lamp run time is 1000 hours
Operating the lamp longer
than 8000 hours may damage
the projector.
Please replace the lamp
<ENTER> to continue
Lamp run time is 1000 hours. Operating the lamp longer than 1000 hours may damage the projector. Please replace the lamp.
When OK (ENTER) is pressed to go on, the warning will be repeated every 30 min.
The total lifetime of the lamp for a safe operation is 1000 hours max. Do not use it longer. Always replace with a same type of lamp.
Call a BARCO authorized service technician for lamp replacement.

Lamp Run Time Warning

Using a lamp for more than 1000 hours is dangerous as the lamp could explode.

Switching to Stand-by.

When the projector is running and you want to go to stand-by, press the stand-by key for 2 seconds until the message 'Saving data,
please wait' is displayed. Do not press any longer on the standby key otherwise the projector will restart.
Saving data, Please wait
4-2
Projector mode indication
Stand-by key
0
9
STANDBY EXIT
7 8
ENTER
5 6
TEXT PAUSE
3
4
SHARPN TINT BRIGHTN
2
1
PHASE COLOR CONTRAST
5976183 BARCOGRAPHICS 6500 31012001
F3
F2 F4
F1 F5
ADJ EXIT
ENTER
PAUSE TEXT
PHASE
9 0
SHARPN
7 8
TINT
6
5
COLOR
3 4
BRIGHTN
1 2
CONTR
TREBLE BALANCE
BASS VOL