Check The Leds - LevelOne WBR-3400TX User Manual

For best Wireless reception and performance, the LevelOne
54Mbps Wireless AP Router should be positioned in a cen-
tral location with minimum obstructions between the
LevelOne 54Mbps Wireless AP Router and the PCs.
Also, if using multiple Access Points, adjacent Access
Points should use different Channels.
2. Connect LAN Cables
Use standard LAN cables to connect PCs to the Switching Hub ports on the LevelOne
54Mbps Wireless AP Router. Both 10BaseT and 100BaseT connections can be used si-
multaneously.
If required, connect any port to a normal port on another Hub, using a standard LAN cable.
Any LAN port on the LevelOne 54Mbps Wireless AP Router will automatically function
as an "Uplink" port when required.
3. Connect WAN Cable
Connect the DSL or Cable modem to the WAN port on the LevelOne 54Mbps Wireless
AP Router. Use the cable supplied with your DSL/Cable modem. If no cable was supplied,
use a standard cable.
4. Power Up
•
Power on the Cable or DSL modem.
•
Connect the supplied power adapter to the LevelOne 54Mbps Wireless AP Router and
power up.
Use only the power adapter provided. Using a different one may cause hardware damage

5. Check the LEDs

•
The Power LED should be ON.
•
The Status LED should flash, then turn Off. If it stays on, there is a hardware error.
•
For each LAN (PC) connection, the LAN Link/Act LED should be ON (provided the PC is
also ON.)
•
The WAN LED should be ON.
•
The WLAN LED should be ON
For more information, refer to Front-mounted LEDs in Chapter 1.
Installation
7