Check The Leds - LevelOne FBR-1800TX User Manual

2. Connect LAN Cables
Use standard LAN cables to connect PCs to the Switching Hub ports on the LevelOne
FBR-1800TX Broadband Router. Both 10BaseT and 100BaseT connections can be used
simultaneously.
If required, connect any port to a normal port on another Hub, using a standard LAN cable.
Any LAN port on the LevelOne FBR-1800TX Broadband Router will automatically func-
tion as an "Uplink" port when required.
3. Connect WAN Cable
Connect the DSL or Cable modem to the WAN port on the LevelOne FBR-1800TX
Broadband Router. Use the cable supplied with your DSL/Cable modem. If no cable was
supplied, use a standard cable.
4. Connect Printer Cable
Use a standard parallel printer cable to connect your printer to the Printer port on the Leve-
lOne FBR-1800TX Broadband Router.
5. Power Up
•
Power on the Cable or DSL modem.
•
Connect the supplied power adapter to the LevelOne FBR-1800TX Broadband Router and
power up.
Use only the power adapter provided. Using a different one may cause hardware damage

6. Check the LEDs

•
The Power LED should be ON.
•
The Status LED should flash, then turn Off. If it stays on, there is a hardware error.
•
For each LAN (PC) connection, the LAN Link/Act LED should be ON (provided the PC is
also ON.)
•
The WAN LED should be ON.
•
The Print Act LED should be ON.
For more information, refer to Front-mounted LEDs in Chapter 1.
Installation
7