Check The Leds - LevelOne FBR-1100TX User Manual

LevelOne Broadband Router User Guide
1. Choose an Installation Site
Select a suitable place on the network to install the LevelOne
Broadband Router.
2. Connect LAN Cable
Connect a 10BaseT cable from a Hub on your LAN to the LAN port on
the LevelOne Broadband Router.
3. Connect WAN Cable
Connect the 10BaseT cable from the DSL/Cable modem to the WAN
port on the LevelOne Broadband Router. Use the cable supplied with
your modem. If no cable was provided, use a standard network cable.
4. Connect Power Adapter
Connect the LevelOne Broadband Router's power adapter to the
LevelOne Broadband Router and power it ON.

5. Check the LEDs

When the LevelOne Broadband Router is powered On, the
Data/Status LED should flash Orange, then turn Green. If it stays
Orange, or flashes Orange/Green there is a hardware problem. For
more information on the LEDs, refer to LED Table in Chapter 1.
10
Only use the power adapter provided.
Using a different one may cause hard-
ware damage.