Qrx Ifb Audio Receive - Zaxcom Nomand User Manual

NOMAD OPERATIONS

QRX IFB audio receive

1. From Nomad:
a. From the main menu, select ZaxNet Setup.
b. Scroll down and select input configure. To be able to use ZaxNet, make sure that input type is set to 8 or
higher.
c. Power cycle Nomad.
d. Return to the ZaxNet setup menu.
e. Make sure IFB Mode is set to RX or TX+RX.
f. Scroll down to RX channels and select FREQ 1 to select which frequency audio will be received on.
Tip: There are several smart phone apps, which will show what Wi-Fi frequencies are being used in the
area. This can be useful in selecting an open frequency.
2. From the QRX:
a. Advance to the IFB extended menu.
b. Set the IFB to TX and set the TX frequency to the same frequency that FREQ 1 was set to on Nomad.
3. From Nomad:
a. Advance to the headphone setup matrix and put a cross point in the corresponding ZNET matrix. To
listen to FREQ 1 select the first box, FREQ 2 the second, etc.
b. Now when that HP matrix is selected the audio being sent from that QRX will be heard. If the IFB Mode
set to TX+RX, Nomad will temporarily stop transmitting over ZaxNet and receive signal while in that
headphone matrix. When that headphone matrix is left, Nomad will start transmitting again.
67
ZaxNet Quick Start Guides