Time Code Setup Menu; Tc Mode; Tc Frame Rate; Tc Displayed - Zaxcom Nomand User Manual

NOMAD OPERATIONS

Time Code Setup Menu

Pressing the TC key a fourth time opens the time code setup menu

TC Mode


FREE-RUN - Time code runs continuously.

REC-RUN -Time code will start to run when Nomad begins to record and will stop when Nomad stops recording.

CJAM - Time code and user bits are continuously updated from a connected external source.

CJAM TC - Time code only is continuously updated from a connected external source.

CJAM UB – User bits only are continuously updated from a connected external source.

TC Frame Rate

From the time code set menu is where Nomad's time code frame-rate is adjusted.
Nomad supports all standard SMPTE frame-rates: 23.98, 24, 25, 29.97, 29.97DF, 30, 30DF

TC Displayed

Sets what time code Nomad will display on the LCD screen.

GENERATOR - Nomad displays the time code from the internal time code generator.

CARD - Nomad displays the time code from the file that is being recorded or playing back.

TC Output

TC out sets the time code source that will be sent to the time code output connector.

GENERATOR - Nomad outputs time code from the internal time code generator.

CARD - Nomad outputs time code from the file that is being recorded or playing back.

Increment User Bits

If incremental user-bits is set to on the user bits will automatically increment with each take.

UB Date Style

If the date is being assigned as the user bits the UB date style determines how the date is displayed.

EU - European (DDMMYY)

US - United States (MMDDYY).

Auto Date Jam

If the auto date jam is set to on Nomad will automatically jam the user bits to the internal date upon boot up.
If auto date is set to off the user bits will stay as previously set.
54
Time Code Key