Resuming Production After Printing Has Stopped - Stratasys Objet30 User Manual

Objet30 User Guide

Resuming Production After Printing has Stopped

If the printing process is interrupted, Job Manager stops sending slices to the
printer. This can happen, for example, if the printing material runs out in the
middle of a print job, and you do not replace the empty cartridge immediately.
After the printer changes to Standby or Idle mode, you need to resume
printing from the Job Manager screen of Objet Studio.
After printing stops, the printer goes into Standby mode, when heating of
the print heads is reduced. About 20 minutes later, the printer goes into
Idle mode, when heating of the print heads is stopped.
To continue printing the model:
1. If the printer is in offline mode, switch it to online mode by clicking the
2. If you don't know why printing has stopped, make sure that the
3. In the Job Manager screen of Objet Studio, click the Resume icon
4. In the Continue from Slice dialog box that appears, confirm the slice
5. If, for any reason, the correct number does not appear in the dialog box,
DOC-34022 Rev. D
red button at the bottom of the printer interface (see Figure 6-3 on page
6-4).
The button changes from red to green (see Figure 6-3 on page 6-4).
connection between the printer and the server computer is active.
number, after checking the printer interface.
Figure 6-10 Printer interface after interrupted printing
Figure 6-11 Continue from Slice confirmation in Objet Studio (Job
Manager screen)
enter the number and click OK.
6 Operating and Maintaining the Objet30 3D Printer
.
6-12