Objet30 User Guide
16. Attach the inlet side of the new filter to the disconnected tube.
Important:
To attach the filter, hold the fitting at the end of the feed tube in place and turn
the filter. Otherwise, the feed tube will be twisted and material might leak.
17. Disconnect the old filter from the outlet tube.
18. Discard the old filter
Caution:
The filter contains uncured printing material. Discard the filter in
accordance with applicable environmental regulations.
19. Cut and remove the cable tie securing the fitting at the end of the outlet
20. R emove the fitting from the end of the tube.
DOC-34022 Rev. D
tube.
Figure 6-113 Tube with cable tie and fitting
6 Operating and Maintaining the Objet30 3D Printer
6-78