Replacing The Waste Container 6 - Stratasys Objet30 User Manual

Objet30 User Guide
8. Replace the cartridge.
When replacing the waste container, hold the waste bag with one hand
l
while connecting the waste tube. Otherwise, the bag will be twisted, and
the flow of waste will be restricted.
Make sure to replace the metal cover over the waste container. Operating
l
the printer without the cover results in an inaccurate measurement of the
waste weight, which will cause waste to overflow into the printer.
Replacing the
If the printer exhaust is not connected to an external ventilation system, a
Odor Filter
built-in activated-carbon filter removes odors from printing materials. This
filter should be replaced regularly (as necessary) to keep your working
environment pleasant. T his is normally done during the preventive-
maintenance routine.
To replace the odor filter:
1. Locate the filter drawer at the rear of the printer and pull it open.
2. Remove the used filter. (You can push it out from underneath the drawer.)
3. Insert a new filter and close the drawer.
DOC-34022 Rev. D
Figure 6-94 Rear of the cartridge printer
Figure 6-95 Odor filter in drawer
6 Operating and Maintaining the Objet30 3D Printer
6-68