Stratasys Objet30 User Manual page 198

Objet30 User Guide
2. Close the printer application.
3. Shut down the printer computer, wait 60 seconds after the monitor goes
Caution:
The monitor goes blank as soon as the remote link terminates—before
computer shut down.
Turning off the before the computer shutdown can cause damage.
4. Open the materials drawer.
Figure 6-121 Material pumps
5. Remove the three screws securing the right printer panel and remove the
Caution:
Remove the screws carefully so that they do not fall and scratch the printer
panel.
DOC-34022 Rev. D
blank, and turn off the main power switch.
panel.
Figure 6-122 Removing the right printer panel
6 Operating and Maintaining the Objet30 3D Printer
6-84