Setting The Printer Connection - Stratasys Objet30 User Manual

Objet30 User Guide
Waste If you move the mouse over the Waste display, the amount of waste in the
container is displayed.
Setting the
When your printer is installed, the server computer is connected to that
Printer
printer. Normally, there should be no reason to change this connection.
Connection
Occasionally, however, you may need to reset the connection, to connect the
server to another printer, or to use Objet Studio in off-line mode (without a
printer connection).
To set (or change) the printer connection:
1. On the Job Manager ribbon, in the 3D Printer group, click
2. In the Set Printer dialog box, click Connect.
DOC-34022 Rev. D
Figure 5-85 C onnecting to a printer (A)
5 Using Objet Studio
.
5-67