Stratasys Objet30 User Manual page 209

Objet30 User Guide
Status
The "S" column shows the results of the test after you run it:
To run the test:
➢ Select the check box and click
After you run the test, the Save and View command buttons are added to the
Built In Tests screen.
Figure 6-139 BIT command buttons
Test Results To save and view a report of all tests:
➢ Use the Save and View command buttons.
DOC-34022 Rev. D
Test successfully completed.
Test failed.
Unknown results. (The test has not been run yet.)
6 Operating and Maintaining the Objet30 3D Printer
.
6-95