Stratasys Objet30 User Manual page 159

Objet30 User Guide
7. When the following screen appears, clean the print heads.
Warning: Hot Surface
The print head orifice plates (bottom surface) may be hot. Do not touch
them with your bare hands, and proceed with caution.
8. Place the mirror on the build tray.
9. Put on the cleaning gloves.
10. Soak the cleaning cloth with alcohol.
11. Clean the orifice plates, with a back-and-forth motion.
12. When the print heads are clean, select the confirmation check box in the
13. Remove the cleaning materials and the mirror from the printer, and close
DOC-34022 Rev. D
Figure 6-60 Clean print heads screen
Use the mirror to make sure that you have removed all of the residue
material.
Figure 6-61 Cleaning the print heads
wizard screen and click Next.
the cover.
6 Operating and Maintaining the Objet30 3D Printer
6-45