Stratasys Objet30 User Manual page 211

Objet30 User Guide
To prepare a new waste container:
1. Assemble the cardboard box, making sure to punch out the perforated
2. Fold a new waste bag—so it fits in the box—and insert the bag's screw-
To replace the waste container:
1. Open the materials drawer.
2. Remove the fireproof cover from the waste container.
3. Unscrew the cap connecting the waste drain tube to the container.
4. Carefully lift out the waste container to remove it from the printer.
5. Close the full container with the cap supplied with the new waste
6. Place the new waste container in the materials drawer, and attach the cap
DOC-34022 Rev. D
sections.
connector into the hole in the top of the box.
Note: Do not close the box until you connect the waste drain tube from the
printer.
Figure 6-141 Removing the waste-container cover
container.
connected to the drain tube.
Important: Hold the waste bag with one hand while attaching the waste
tube. Otherwise, the bag will be twisted, and the flow of waste will be
restricted.
6 Operating and Maintaining the Objet30 3D Printer
6-97