Stratasys Objet30 User Manual page 18

Objet30 User Guide
First Aid for Working with Printing Materials
In general, try to avoid direct contact with uncured printing material. If skin
or eyes come into contact with it, wash the area immediately and thoroughly
with water, and follow these first-aid instructions.
The Material Safety Data Sheet (MSDS) that accompanies printing
materials contains important safety information. Keep this in an accessible
place where these materials are used and stored.
Contact with
If uncured printing material comes in contact with skin, wash the affected
Skin
area immediately and thoroughly with soap and cool water, then remove
contaminated clothing. Pay particular attention to flushing the hair, ears,
nose and other parts of the body that are not easily cleaned.
➢ Use cool water to prevent skin pores from opening, so that the liquid
➢ Do not use solvents to clean skin.
➢ If large areas of skin have been exposed, or if prolonged contact results in
➢ Avoid the accidental transfer of printing material from the hands to other
➢ If protective cream was used, do not reapply it until the skin has been
Contact with
If uncured printing material comes in contact with the eyes, flush
Eyes
immediately with large amounts of water for 15 minutes and seek medical
attention.
➢ Avoid sunlight, fluorescent light, and other sources of ultraviolet radiation.
Wearing contact lenses when handling liquid printing materials is not
recommended. If the liquid splashes into the eyes when contact lenses are
worn, immediately remove the lenses and flush the eyes with water.
➢ Clean and disinfect the contaminated lenses.
➢ Do not wear contact lenses until eye irritation disappears.
Ingestion
If printing material is swallowed, refer to the instructions included with the
cartridge. Seek medical attention immediately.
DOC-34022 Rev. D
material does not easily penetrate the skin.
blisters, seek medical attention. In any case, if irritation persists, seek
medical attention.
areas of the body, especially to the eyes.
completely cleansed.
2 Safety
2-8