Stratasys Objet30 User Manual page 206

Objet30 User Guide
2. Secure the Model pump to the printer with two screws.
Returning
To return the printer to working order:
Printer to
1. Remove the cleaning cloths from the waste compartment and make sure
Working Order
2. Place the waste container in the materials drawer, and attach the cap
Important:
Hold the waste bag with one hand while attaching the waste tube. Otherwise
the bag will become twisted, and the flow of material will be restricted.
DOC-34022 Rev. D
Insert and tighten the securing screw you removed before, and tighten the
screw that you loosened.
Figure 6-134 Model pump in the working position
that the compartment is clean.
connected to the drain tube.
Figure 6-135 Waste container with waste tube attached
6 Operating and Maintaining the Objet30 3D Printer
6-92