Stratasys Objet30 User Manual page 152

Objet30 User Guide
8. Pull out the roller waste collector, taking care not to touch or damage the
Warning
The scraper is very sharp! Proceed with caution.
9. Inspect the roller waste collector.
To install the roller waste collector:
1. Carefully insert the roller-waste-collector unit.
2. Secure the unit evenly, by alternately tightening the screws.
3. Return the drain-tube release mechanism to its original position by
4. Move the print block back to the middle of the printer.
DOC-34022 Rev. D
scraper.
Figure 6-48 Roller waste collector
❒ If the scraper is damaged, replace the entire roller-waste-collector unit.
❒ If the scraper is not damaged, carefully remove any waste from the
waste channel, taking care not to damage the scraper. If necessary, use
IPA or ethanol to dissolve residue material in the waste channel and
on the scraper.
Note: The waste collected in this unit contains uncured resin. Dispose of it in
accordance with applicable environmental regulations.
pushing it in all the way.
Figure 6-49 Returning the drain tubes from to the waste collector
6 Operating and Maintaining the Objet30 3D Printer
6-38