Stratasys Objet30 User Manual page 2

Copyright
Copyright © 2016 Stratasys Ltd. All rights reserved.
This documentation contains proprietary information of Stratasys Ltd. This information is supplied solely to assist authorized
users of Objet30 3D printing systems. No part of this document may be used for other purposes, and it may not be disclosed to
other parties.
The specifications on which this document is based are subject to change without notice.
Trademarks
The following are registered trademarks of Stratasys Ltd.: Stratasys
The following are trademarks of Stratasys Ltd.: Objet30, Objet30-Pro, Objet30-OrthoDesk, Objet24, , PolyJet, Objet Studio,
Job Manager.
Microsoft and Windows XP are trademarks of Microsoft Corporation.
All names of products and services cited in this book are trademarks or registered trademarks of their respective companies.
FCC Compliance
The equipment referred to in this guide has been tested and found to comply with the limits for a Class A device pursuant to
part 15 of the FCC rules. These limits provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. Stratasys 3D printing systems generate, use and can radiate radio-frequency energy
and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the
user will be required to correct the interference at his own expense.
The 3D printer referred to in this guide contains a transmitter module, FCC ID YH6-RFID.
NOTE: Stratasys is not responsible for radio or TV interference caused by unauthorized modification to this equipment.
Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment.
Equipment Recycling
In the European Union, this symbol indicates that when the last user wishes to discard a product, it must be sent to appropriate
facilities for recovery and recycling. For information about proper disposal, check your purchase contract, or contact the
supplier of the equipment.
Limitation of Liability
The product, software or services are being provided on an "as is" and "as available" basis. Except as may be stated
specifically in your contract, Stratasys Ltd. expressly disclaims all warranties of any kind, whether express or implied,
including, but not limited to, any implied warranties of merchantability, fitness for a particular purpose and non-infringement.
You understand and agree that Stratasys Ltd. shall not be liable for any direct, indirect, incidental, special, consequential or
exemplary damages, including but not limited to, damages for loss of profits, goodwill, use, data or other intangible losses (even
if Stratasys has been advised of the possibility of such damages), resulting from: (i) the use or the inability to use the product or
software; (ii) the cost of procurement of substitute goods and services resulting from any products, goods, data, software,
information or services purchased; (iii) unauthorized access to or alteration of your products, software or data; (iv) statements
or conduct of any third party; (v) any other matter relating to the product, software, or services.
The text and drawings herein are for illustration and reference only. The specifications on which they are based are subject to
change. Stratasys Ltd. may, at any time and without notice, make changes to this document. Stratasys Ltd., for itself and on
behalf of its subsidiaries, assumes no liability for technical or editorial errors or omissions made herein, and shall not be liable
for incidental, consequential, indirect, or special damages, including, without limitation, loss of use, loss or alteration of data,
delays, or lost profits or savings arising from the use of this document.
DOC-34022 Rev. D
® ® ®
, Objet , FullCure .