Stratasys Objet30 User Manual page 181

Objet30 User Guide
4. Select the confirmation check box and click Next.
5. In the next wizard screen, observe the numbers and wait until the level is
6. Select the check box, and click Next.
7. Click Done in the final wizard screen.
DOC-34022 Rev. D
Figure 6-91 Confirmation of cartridge removal
relatively stable—two units above or below the average level shown.
Figure 6-92 Level stabilization
If you need to calibrate more than one load cell, the next calibration
screen appears. Repeat steps 5 and 6 until all of the load cells are
calibrated.
Figure 6-93 Final wizard screen
6 Operating and Maintaining the Objet30 3D Printer
6-67