Stratasys Objet30 User Manual page 176

Objet30 User Guide
calibrate the print heads to the best working configuration—see "Optimizing
(Calibrating) Print Heads" on page 6-43. After this procedure, you should run
the Head Alignment wizard before printing models.
If installation problems are detected, the wizard alerts you and instructs you
how to continue (see "Installation Problems", next).
Installation
If the printer detects that there is a problem after you install print heads,
Problems
relevant warning screens appear.
• If the print head you installed is not new—that is, it was previously
• If the printer software does not detect the replaced head, the following
DOC-34022 Rev. D
removed from a printer—the following message appears.
Figure 6-81 Used print head message
❒ To continue with the installation of this print head, click Yes.
❒ To remove this print head and install a new one, click No.
warning screen appears.
Figure 6-82 Incorrect-installation screen, showing which head(s) to re-
insert
If this happens:
a. Re-insert the print-head driver card into its socket.
b. In the wizard screen, select the check box to confirm that you have re-
inserted the card, and click Next.
6 Operating and Maintaining the Objet30 3D Printer
6-62