Stratasys Objet30 User Manual page 154

Objet30 User Guide
4. In the wizard screen, select the check box to confirm that the cover is
5. When instructed to do so, place the transparency on the build tray— near
6. Make sure that the transparency sheet is lying flat, and tape it to the tray.
7. In the wizard screen, select the check box to confirm that the
8. When the following screen appears, remove the transparency.
DOC-34022 Rev. D
closed, and click Next.
Figure 6-51 Door is closed confirmation screen
the left and rear edges of the tray, as shown in the following figure.
Figure 6-52 Positioning the transparency on the build tray
transparency sheet is on the build tray, and click Next.
The printer prints the head alignment test on the transparency.
Figure 6-53 Head Alignment wizard—steps 8–10
6 Operating and Maintaining the Objet30 3D Printer
6-40