Electrical; Spark Plug; Air Filter Cleaning - BOMBARDIER outlander max series Operator's Manual

Loosen clamp and remove air filter.
1
V07C0HY
1. Clamp
2. Air filter

Air Filter cleaning

Pour cleaning solution (P/N 219 700 341) or
an equivalent into a bucket. Put the filter in to
soak.
While filter soaks, clean inside the air box.
Rinse the filter with warm water until all clean-
ing solution disappears.
Then, let the filter dry completely.
When the filter is dried, re-oil with air filter oil
(P/N 219 700 340) or an equivalent.
Air Filter Installation
Properly reinstall removed parts in the re-
verse order of their removal.
2

Electrical

WARNING
Unless otherwise indicated, always turn ig-
nition switch to the OFF position before per-
forming any maintenance or repair on elec-
trical system.

Spark Plug

Removal
Unplug the spark plug cable.
Unscrew the spark plug one turn.
Clean the spark plug and cylinder head with
pressurized air if possible.
WARNING
always wear safety goggles when using
pressurized air.
Unscrew spark plug completely then remove
it.
Installation
Prior to installation make sure that contact
surfaces of cylinder head and spark plug are
free of grime.
Using a feeler gauge, set the spark plug gap
to 0.7 mm (0.27 in).
Apply anti-seize lubricant over spark plug
threads to prevent a possible seizure.
Screw spark plug into cylinder head by hand
and tighten with a torque wrench and a proper
socket.
Torque spark plug to 20 N·m (15 lbf·ft).
127