Troubleshooting - BOMBARDIER outlander max series Operator's Manual

TROUBLESHOOTING

Engine does not turn
1. Ignition switch is in the OFF position.
– Place switch to the ON position.
2. Transmission is not set on PARK or NEUTRAL.
– Set transmission either in PARK or in NEUTRAL or press the brake lever.
3. Burnt fuse.
– Check main fuse condition.
4. Weak battery or loose connections.
– Check charging system fuse.
– Check connections and terminals condition.
– Have the battery checked.
– Contact an authorized Bombardier ATV dealer.
Engine turns over but fails to start
1. Burnt fuse.
– Check main fuse condition.
2. Mixture not rich enough to start cold engine.
– Check fuel tank level and check starting procedure, particularly use of the choke.
3. Flooded engine (spark plugs wet when removed).
– Refer to SPECIAL PROCEDURES.
4. No fuel to the engine (spark plugs dry when removed).
– Check fuel tank level; turn fuel valve to ON (also try on RES). A failure of the fuel pump
or carburetor may have occurred.
– Contact an authorized Bombardier ATV dealer.
5. Spark plug/ignition (no spark).
– Check main fuse condition.
– Remove spark plug then reconnect to ignition coil.
– Check that ignition switch and/or engine stop switch is/are at the ON position.
– Start engine with spark plug grounded to the engine away from spark plug hole. If no spark
appears, replace spark plug.
– If trouble persists, contact an authorized Bombardier ATV dealer.
6. Engine compression.
– As the engine is pulled over with the rewind starter, "cycles" of resistance should be felt
as piston goes past top dead center. If no pulsating resistance is felt, it suggests a major
loss of compression.
– Contact an authorized Bombardier ATV dealer.
Engine lacks acceleration or power
1. Fouled or damaged spark plugs.
– Check item ENGINE TURNS OVER BUT FAILS TO START.
2. Lack of fuel to engine.
– Check item ENGINE TURNS OVER BUT FAILS TO START.
3. Carburetor adjustments.
– Contact an authorized Bombardier ATV dealer.
140