Operating Instructions; General; Initial Cold Starting - BOMBARDIER outlander max series Operator's Manual

OPERATING INSTRUCTIONS

General

The transmission lever must be on PARK or
NEUTRAL to allow engine to start.
NOTE: For your convenience, an override
mode allows the engine to be started with the
transmission lever in any position. Press and
hold the brake lever or the brake pedal while
pressing the start button.
To start the engine, place the engine stop
switch to RUN, insert the key in the ignition
switch and turn to ON, then press the start
button.

Initial Cold Starting

Insert key in ignition switch and turn to ON.
NOTE: Do not forget to place the engine stop
switch to RUN.
In cold weather, under 0°C (32°F), place the
choke lever in full position.
V07I09Z
TYPICAL
1. Full choke position
1
Press the start button and hold until the en-
gine starts.
CAUTION: Do not hold the start button more
than 30 seconds. A rest period should be ob-
served between the cranking cycles to let the
starter cool down. Pay attention not to dis-
charge the battery.
NOTE: The throttle can be used to help start-
ing the engine faster. Press the throttle lever
slightly; If it is pressed too much, the choke
system will not be activated.
Release the start button immediately when
the engine has started.
After a few seconds, move the choke lever
from full choke position to an intermediate po-
sition until the best engine RPM is achieved.
NOTE: Over using the choke may flood the
engine and make it hard to start. Refer to
SPECIAL PROCEDURES if it occurs.
When the engine is warm, push the choke le-
ver to OFF, and release brakes.
V07I08Z
TYPICAL
1. OFF position
1
111