Trip Meter; Indicator Lamps - BOMBARDIER outlander max series Operator's Manual

Plug connectors to change units from miles to
kilometers. Unplug to return to miles reading.
Fix the change wires to the harness with new
locking ties.
Display Selector Button
The odometer always appears when turning
the ignition switch ON (either ON position). To
change the display to the trip meter, depress
the display selector button.
V07I1BY
TYPICAL
Depressing display selector button again will
change display for the hourmeter. Push dis-
play selector button again to return to odom-
eter.
Odometer
Odometer records the total distance travelled
either in miles or kilometers.

Trip Meter

The trip meter records distance travelled
since it has been reset. Distance travelled is
displayed either in miles or kilometers.
It can be used to establish a fuel tank range
or distance between 2 way points for
instance.
Push and HOLD display selection button for
2 seconds to reset the trip meter.
Hourmeter
The hourmeter records engine running time in
hours and minutes.

Indicator Lamps

High Beam (BLUE)
Indicates headlamps are in high beam
mode.
4-Wheel Drive (AMBER)
Indicates the 4WD system is activated.
Engine Temperature (RED)
Indicates the engine is overheating.
If engine overheats, refer to ENGINE
OVERHEAT in SPECIAL PROCEDURES.
CAUTION: If the light does not turn off
right after engine starting, stop engine.
See an authorized Bombardier ATV deal-
er. Do not use the vehicle until repaired.
93