Engine Stop Switch - BOMBARDIER outlander max series Operator's Manual

1
V07I03Y
TYPICAL
1. Headlamp switch
2. Low beam position
3. High beam position
NOTE: Place ignition switch to ON "without
light" position to close the headlamp.
V07A1IY
ON POSITION WITHOUT LIGHT

Engine Stop Switch

Located at the middle of multi-function switch.
The engine will turn over but will not start if the
engine stop switch is turned to OFF position.
3 2
TYPICAL
1. Engine stop switch
This switch can be used to stop engine and
as an emergency control.
NOTE: While engine can be stopped by turn-
ing ignition key OFF, we recommend the en-
gine be stopped by the engine stop switch.
To stop engine, fully release throttle lever then
use the engine stop switch.
1
V07I05Y
89