BOMBARDIER outlander max series Operator's Manual page 124

Allow enough time for oil to flow out of oil filter.
Remove the right engine cover.
Unscrew the oil filter cover.
1
V07C04Y
TYPICAL
1. Oil filter cover
Remove the oil filter and replace with a new
filter.
NOTE: Check the cover O-ring and change it
if necessary.
Wipe out any oil spillage on engine.
Change gasket on oil drain plug. Clean gas-
ket area on engine and oil drain plug then re-
install plug. Refill engine at the proper level
with the recommended oil. Refer to SPECIFI-
CATIONS for capacity.
Start engine and let idle for a few minutes. En-
sure oil filter area and oil drain plug areas are
not leaking.
122
Stop engine. Wait a while to allow oil to flow
down to crankcase then check oil level. Refill
as necessary.
Dispose of oil as per your local environmental
regulations.
Oil Strainer Cleaning
The oil strainer must be cleaned every 200
hours or every 2 years or every 6000 km
(3730 mi.).
Contact an authorized Bombardier ATV
dealer.
Coolant Replacement
WARNING
In order to avoid getting burned, do not re-
move the radiator cap or loosen the coolant
drain plug if the engine is hot.
Open the access panel and remove the radi-
ator cap.
V07C05Y
1. Radiator cap
1