Electrical; Spark Plug; Battery - BOMBARDIER 2006 outlander max 400 Operator's Manual

ELECTRICAL

WARNING
Unless otherwise indicated, always turn ig-
nition switch to the OFF position before per-
forming any maintenance or repair on elec-
trical system.

Spark Plug

Removal
Unplug the spark plug cable.
Unscrew the spark plug one turn.
Clean the spark plug and cylinder head with
pressurized air if possible.
WARNING
Always wear safety goggles when using
pressurized air.
Unscrew spark plug completely then remove
it.
Installation
Prior to installation make sure that contact
surfaces of cylinder head and spark plug are
free of grime.
Using a feeler gauge, set the spark plug gap
to 0.7 mm (0.27 in).
Apply anti-seize lubricant over spark plug
threads to prevent a possible seizure.
Screw spark plug into cylinder head by hand
and tighten with a torque wrench and a proper
socket.
Torque spark plug to 20 N·m (15 lbf·ft).

Battery

WARNING
Never charge a battery while installed in the
vehicle.
Removal
Disconnect BLACK (-) cable first then RED
(+) cable.
WARNING
Always respect this order for disassembly;
disconnect BLACK (-) cable first.
Remove the holding strap then pull the bat-
tery out of frame.
V07G0OY
1. Battery
2. Holding strap
2 1
135