V01G1VY
TYPICAL
1. Housing hole
2. Socket slot
Install the socket snap.
V01G1WY
TYPICAL
Install the protective rubber sleeve and con-
nect the headlamp connector.
NOTE: Take care do not pry the socket termi-
nals.
1
2
Adjust beam aiming as follows.
Turn knobs to adjust beam height and side
orientation to your convenience. Adjust both
headlamps evenly.
1
V07G0KY
1. Headlamp
2. Beam height adjustment
3. Beam side adjustment
Front Position Lamp
To replace the front position lamp bulb located
in the headlamp housing, proceed as follows.
Disconnect both connectors on the position
lamp socket.
V01G1RZ
1. Position lamp connectors
2. Headlamp housing
NOTE: The headlamp has been removed to
ease the comprehension.
3
2
1
2
131