Electrical; Spark Plug; Battery - BOMBARDIER outlander 800 Operator's Manual

ELECTRICAL

WARNING
Unless otherwise indicated, always turn
ignition switch to the OFF position before
performing any maintenance or repair on
electrical system.

Spark plug

Removal
Remove side panels.
Unplug the spark plug cable.
Unscrew the spark plugs one turn. Clean the
spark plug and cylinder head with pressurized
air if possible.
WARNING
Always wear safety goggles when using
pressurized air.
Unscrew spark plugs completely then remove
them.
RH SIDE — REAR CYLINDER
1. Spark plug
LH SIDE — FRONT CYLINDER
1. Spark plug
Installation
Prior to installation make sure that contact
surfaces of cylinder head and spark plug are
free of grime.
Using a feeler gauge, set the spark plug gap
between 0.6 to 0.7 mm (0.24 to 0.27 in).
Apply anti-seize lubricant over spark plug
threads to prevent a possible seizure.
Screw spark plug into cylinder head by hand
and tighten with a torque wrench and a proper
socket.
Torque spark plugs to 20 N·m (15 lbf·ft).

Battery

WARNING
Never charge a battery while installed in
vehicle.
Removal
Disconnect BLACK (-) cable first then RED
(+) cable.
WARNING
Always respect this order for disassembly;
disconnect BLACK (-) cable first.
107