Maintenance; Engine/Transmission - BOMBARDIER outlander max series Operator's Manual

MAINTENANCE

While reading this Operator's Guide, remember that:
Indicates a potential hazard that, if not avoided, could result in serious injury or death.
WARNING
Unless otherwise specified, engine should
not be running for all maintenance proce-
dures. Before performing any service or in-
spection operation on the vehicle, wait until
the engine and exhaust have cooled down
to avoid getting burned.
WARNING
Should removal of a locking device (e.g.
lock tabs, self-locking fasteners, etc.) be re-
quired when undergoing disassembly/as-
sembly, always replace with a new one.
The following covers the maintenance items
that can be performed by the customer if de-
sired. Other items found in maintenance chart
mu s t b e p erf orm e d by a n a u th or iz ed
Bombardier ATV dealer.
NOTE: Among other things, this section
gives the procedures to replace the liquids.
Refer to LIQUIDS for procedures to check
levels and refill.
WARNING

Engine/Transmission

Oil Change and Oil Filter
Replacement
Oil and filter are to be replaced at the same
time. Oil change should be done with a warm
engine.
The engine oil can be very hot. In order tp
avoid getting burned, do not remove the en-
gine drain plug or the filter cover if the en-
gine is hot. Wait until engine oil is warm.
Ensure vehicle is on a level surface.
Remove dipstick.
Clean the oil drain plug area.
Place a drain pan under the oil drain plug
area.
Unscrew oil drain plug.
V07C03Y
TYPICAL
1. Oil drain plug
WARNING
1
121