Network Configuration - Christie CCM-LX User Manual

Network configuration

Click Network on the main menu. The following setting page is displayed.
The IP Address, Subnet Mask, Default Gateway, DNS (Domain Name Server)
and projector name are set up on this Setting sub menu.
The IP address and Subnet Mask have been configured already in chapter "Installation".
If you want to change them or configure default gateway or DNS, perform them in this
page. If you change them, the network unit begins restarting and it takes about 20 sec-
onds. Close (Quit) the web browser and access to the login page again in 20 seconds.
Item Description
IP address .............Sets IP address of the projector.
Subnet mask .......Sets Subnet mask. Normally sets [255.255.255.0].
Default gateway* 1 .....Sets IP address of the default gateway (Router).
DNS* ....................... Sets IP address of the DNS server. Must be set when using the e-mail function.
2
PJ name* .............. Sets name of the projector. (64 characters maximum)
3
You must use the number specified by your administrator. The address must be entered as a
group with four numbers split by a dot like [192.168.001.101].
*1 Set [0.0.0.0] if the network does not provide the gateway (router).
*2 Set [0.0.0.0] if you do not use the function E-Mail alert.
*3 If you use the DNS server, register the host name registered to the DNS server as a projector
name. You can access with this projector name from any computers in your network. If you do
not use the DNS server, access with the assigned IP address to the projector.
* All the network setting will reset to the default when setting [0.0.0.0] of the IP Address.
CCM-LX User Manual
Downloaded from ProjectorsManual.com Manuals
020-000326-01 Rev.1 (10-2010)
The numerical value is a setting example.
Network configuration
37