Network Configuration - Christie CCM-LX User Manual

Chapter 2 Installation

Network configuration

Confirmation of the network menu
When installing this product to the projector, the built-in network function is not available,
and this product are activated automatically. If not activated, the product may not have
been installed correctly. Please check item "Mounting". (
Configure the network
Before performing the network configuration, prepare network address numbers (IP
Address, Subnet Mask, Default Gateway, DNS) assigned to the projector. Ask your network
administrator for the network address.
For example, the case where the following network address is set up is explained.
IP Address
Subnet Mask
Default Gateway
DNS
The default network configuration is set as follows.
IP Address
Subnet Mask
Default Gateway
DNS
1.
Setting the Network mode
Turn on the projector and select "Network" in the Main menu. Select "Network" in the
Network menu, and press point button
Select "On" and press SELECT button. Then the Menu will disappear, the "Please wait..."
message will appear, and switching operation will start. After completing the operation,
the message will disappear.
The network unit begins restarting each time the mode is set "On".
Change the mode to "On" then the "Please wait..." message will appear and after completing the
operation, the message will disappear.
20
Downloaded from ProjectorsManual.com Manuals
: 192.168.1.201
: 255.255.255.0
: 192.168.1.1
: 0.0.0.0
: 192.168.0.2
: 255.255.255.0
: 0.0.0.0
: 0.0.0.0
or SELECT button.
p.18)
CCM-LX User Manual
020-000326-01 Rev.1 (10-2010)