Christie CCM-LX User Manual page 124

Chapter 7 Appendix
Q
Can I update the firmware of the network unit.
A
It is possible to update the firmware through the network. It is required to have a
special tool for the updating. For further information please consult your local deal-
er. The version number of the firmware is indicated on the lower part of the "Initial
Setting" page.
Network capture
Q
Why doesn't the computer screen appear on the projected screen?
A
1. Make sure that the input mode of the projector is "Network".
2. Make sure that the Network Capture icon on the task bar of the computer is
active. (
3. Check the parameter set up. (
Make sure that the numbers of the capture port is the same as the projector's
port number. The default port number is 9000. If the alert message "Invalid Port
No." appears, your computer may be using this port number already. In this case,
use another port number.
4. Check the IP address of the computer is registered to the network unit correctly.
( p.72)
5. Make sure that your computer is not using the firewall function. The network unit
may not be able to use the port due to this firewall function. In this case, please
turn off this function temporarily. There are also some port limitations on the
network equipment such as router. Please consult your network administrator.
122
Downloaded from ProjectorsManual.com Manuals
p.70)
p.71)
CCM-LX User Manual
020-000326-01 Rev.1 (10-2010)