Christie CCM-LX User Manual page 43

When PJ lamp replacement time is reached:
TITLE: Message from projector
10-03-2005 00:59
Projector Model Name: model name
TCP/IP: 192.168.1.201 Projector Name: Proj05
It sends you following message.
*The projector lamp has reached replacement time.
Lamp 800 h
Replace it with a new lamp immediately. If the projector is used without replacing it with a
new lamp, the alert mail is sent to users in every power-on of the projector. This alert mail will
not be sent when unchecking the mail sending condition "When PJ lamp replacement time is
reached.".
When internal PJ temperature is too high:
TITLE: Message from projector
10-03-2005 00:59
Projector Model Name: model name
TCP/IP: 192.168.1.201 Projector Name: Proj05
It sends you following message.
* The Projector lamp is turned off, because internal Projector temperature is too high.
Wait for the completion of the cooling process and make sure the projector has been turned
into Standby. Then turn the projector on again.
If the Indicator continues flashing, check the air filter for dust accumulation.
[A] 81.5 degrees fahrenheit [B] 134 degrees fahrenheit [C] 95.6 degrees fahrenheit
Temperature of Sensor B is too high.
The network unit let users know the information which thermal sensor [A], [B] or [C] inside
the projector detected the abnormal temperature risen and so the projector was turned off.
Please refer to item "Power control and status check" (
and each temperature . Also see the owner's manual of the projector for further details.
When PJ needs service:
TITLE: Message from projector
10-03-2005 00:59
Projector Model Name: model name
TCP/IP: 192.168.1.201 Projector Name: Proj05
It sends you following message.
*Maintenance requirement from Projector is detected.
Check up LED status of projector and consult with the dealer.
AD, 3.3V
KS, 3.3V
.... ....
MAIN, 3.3V
.... ....
The projector lamp was turned off, because the projector power circuit failed. Unplug the
AC power cord and plug it, and then turn on the projector once again to verify operation. If
the problem still persists, unplug the AC power cord and ask servicing to a qualified service
personnel with the error information.
CCM-LX User Manual
Downloaded from ProjectorsManual.com Manuals
020-000326-01 Rev.1 (10-2010)
OK
OK
....
Error information
NG
....
p.46) for the location of the sensors
E-mail setting
41